Chipmate Body Filler 235 + Hardner(1.54 Kg + 32 Gms) Set

" Chipmate Body Filler 235® " - a butter like, two part body filler, that can be powder coated at ambient temperature.

Surface Preparation & Application Instructions

Surface Preparation

• First, clean the application surface thoroughly; there should not be any traces of oil, grease, or even fine dust or loose particles on the application surface.
• If the application surface is smooth, then do some mild sanding to enhance the adhesion.
• Better use some good quality thinner & clean cloth (for final surface cleaning)
• Then, wait for 2 to 3 minutes, so that the thinner evaporates.

Application Instructions

• Open the can lid (Chipmate Body Filler 235 ®) and take a small portion (say 25 grams or so) out onto a clean metal plate.
• Add approx. 2% Curing Accelerator (red-coloured paste, supplied in a tube) and mix well.
• And apply the body filler paste into voids/gaps / over scratches as shown in the application video (within 3 to 4 minutes). Apply with pressing action to avoid air bubbles or air entrapment during body filler paste application.
• Then, wait for about 40 minutes to 60 minutes (so that the putty cures, ready for sanding).
• Use P80 - P100 for sanding and then final sanding with P180 – P220.
• Do not use water/thinner or any other liquids during or after sanding (under any circumstances). Using of above may change the properties of body filler and you may not get desired end-results after powder coating.
• After sanding, clean the job with compressed air or clean cloth and straightway powder coat the job (no usual pre-treatments prior to powder-coating at this stage).