Dow Corning Sealant(785) White 310 Ml(12Nos/Ctn)

Dow Corning® 785 Sanitary Acetoxy Silicone is a one-part, silicone sealant specifically designed for the sealing of sanitary fittings, including baths, showers, sinks, urinals and ceramic tile joints. This product is mildew, fungus resistant and bacteriostatic. It is better protected against bacterial growth.

FEATURES

• Fungus and mildew resistant
• Bacteriostatic sealant
• Gloss finish
• Conforms to ISO 11600-F-20LM
• Resistant to ozone, ultra-violet radiation and temperature extremes

TECHNICALSPECIFICATIONS AND STANDARDS

Dow Corning® 785 Sanitary Acetoxy Silicone conforms to ISO 11600-F20LM. Performance related to mildew and fungus resistance has been tested in accordance with the ISO-Norm 846. Bacteriostatic performance has been tested to ISO 22196:2007 for MRSA, E.Coli and Salmonella.

HOW TO USE

Surface Preparation

Ensure that surfaces to be sealed are clean, dry, sound and grease-free. Clean non-porous surfaces with Dow Corning® R40 Universal Cleaner or methylated spirits, and dry thoroughly with a clean, oil and lintfree cloth before application of sealant.

Note: When using any solvent, always provide adequate ventilation. Avoid heat, sparks and open flames. Use solvent-resistant gloves. Observe and follow all precautions listed on the solvent container label.

Masking

Areas adjacent to the joints should be masked with tape to prevent contamination of the substrates and to ensure a neat sealant line. Masking tape should be removed immediately after tooling.

Priming

All joint surfaces other than glass and glazed ceramics should be primed. For specific advice, contact one of the regional service centres for technical assistance.

Back-Up Materials

When back-up material is required, a closed-cell polyethene backer rod is recommended. Low-tack polyethene tape should be used in joints too shallow to allow the use of a backer rod. Back-up materials provide back pressure and prevent three-sided adhesion that limits sealant movement capability.

Finishing

The joint should be tooled within 5 minutes of application to ensure good contact between the sealant and the substrate. Tooling of the sealant also gives a smooth, professional finish

Clean-Up

Excess sealant may be cleaned off tools and non-porous surfaces whilst in an uncured state using DOWSIL R-40 Universal Cleaner. If sealant is misapplied to porous substrates, it should be left until it is just cured and then removed by peeling, cutting or other mechanical means. Care should be taken not to damage plastic or coated surfaces

Joint Design

The sealant joint width should be designed to accommodate the movement capability of the sealant. When designing joints using DOWSIL 781 Acetoxy Sealant, the minimum width should be 6 mm. For joints between 6–12 mm wide, a seal depth of 6 mm is required. For joints above 12 mm wide, a width-to-depth ratio of 2:1 should be used. In situations where fillet joints are needed, a minimum of 6 mm sealant bite to each substrate is recommended. For joint dimensions greater than 25 mm, please contact one of the regional service centres for technical assistance.

Click here to visit our corporate site to learn about more products.